P.38 variations (Orv Reichert & p38forum.com)

Different P.38 variations (markings) produced during the nazi-regime will be discussed in this section. For most of the P.38 pistols it is really easy to determine the production date from the markings on the pistol (manufacturer + serial number + prefix/suffix letter). You can download a guide in the "tech section" where all the production dates for pistols can be found. The different variations and corresponding markings will be discussed below.

 

Walther: The AP-serie

The ArmeePistole (army pistol) was the very first prototype/predecessor of the P.38 and was already produced in 1935 by Walther in small quantities (highest serial number known is 55). This pistol had a concealed hammer and extractor. Only a handfull of those pistols were produced because the German army decided to go for the more advanced P.38. The grips have a very distinct look. They are checkered and have round loopholes for the lanyard.

 

P38 AP model

Walther: The HP-serie

The Walther HP (Heerespistole) was produced in parallel with the P.38 for the commercial market. Production started halfway 1939. About 25.000 HP pistols were produced in mainly 9mm and also a few in 7.65mm. Around 1500 Walther HP pistols (serial number range 1000-2500) were exported to Sweden in 1939-40 to be used by the Swedish army under the name m/39. The grips of the Swedish m/39 have round loopholes for the lanyard and are checkered.

HP Walther

Walther : The zero-serie

The 0-Series was the first official P.38 variation issued to the German army. This variation is produced between june 1939 and may 1940. Serial numbers of this variation always start with a 0, hence the name 0-Series. Determination of a 0-Series pistol is easy. The Walther banner and P.38 model indication are stamped on the left side of the slide with the serial number next to it. All parts of the 0-Series pistols are stamped with the Walther acceptance stamp E/359 and the sight is painted White/red. The bakelite grips are black checkered and have a round loophole for the lanyard. Most of the P.38 pistols produced after this variation have rectangular loopholes. Magazines are stamped on the housing with the respective serial number and spare mags have an additional + in front of the serial number.

P38 0-series

Walther: 480 serie

In 1940 the German army decided to use secret codes on weapons to designate the manufacture. The Germans were afraid that the Allied forces could easily locate the German weapon production sites and bomb them when they knew the manufacturer. In June and July 1940 Walther used the secret code 480. The P.38 pistols produced in this period are therefore stamped with 480. The serial number was stamped on the slide. A schematical drawing is shown below. 480 is also stamped on the triggerguard.

P38 480 serie

Walther: The AC serie

The secret code 480 for the Walther factory was already abandoned after two months use and replaced by a new code. This new code was ac and was introduced in august 1940. In addition to the secret code the last two digits of the year of production were also stamped on the slide. There are periods were ac + production year were stamped next to eachother and periods where this combination was stacked. Most of the serial numbers also have a suffix letter.

Walther used serial numbers ranging from 1 to 10,000. The firm started over at 1 when the number 10,000 was reached. To ensure that every pistol had a unique serial number, the Germans added a suffix letter. The letter went up one character each time the serial number once more started at 1. At the beginning of a new year, both the serial numbers and suffix letters again started over. The first 10,000 pistols produced at the start of the year had no suffix letter. For example: The 25,000th pistol produced in a certain year had serial number 5000b, and the 35,000th pistol produced had serial number 5000c. The combination of year + serial number + suffix (or no suffix for the first 10,000 pistols) is unique for every pistol. From this combination it is easy to determine the production date of the pistol. The goal of every P.38 manufacturer was to produce 10.000 P.38 pistols every month. So every month started with a higher suffix letter. Below is a schematical picture of an ac variation.

walther single line

During Walther production some minor technical improvements were introduced in the design, but that's too detailed to discuss on this website. At the beginning of the P.38 all the parts were stamped with the Walther acceptance code E/359. In the years after, fewer and fewer parts were stamped with this mark.

 

Mauser: byf series

In 1942 the Mauser factory started the production of P.38 pistols to fulfill the huge demand for these pistols by the German army. The secret code for Mauser is byf and is stamped on the slide just above the production year (last two digits).

Mauser employed a comparable serial numbering system to the one used by Walther. Serial numbers ranged from 1 to 10,000. Mauser started over at serial number 1 each time the number 10,000 was reached. After the first 10,000 pistols were completed, the firm added a suffix letter to ensure that each pistol had a unique serial number. The suffix letter increased each time the plant started at serial number 1 again. In contrast to Walther, Mauser did not start over with serial numbers at the beginning of every year. After reaching serial number 10,000z in late 1944, Mauser started again with serial number 1, without a letter suffix. The combination serial number + suffix + production year is unique for every Mauser pistol.The Mauser acceptance stamp is E/135 (until midd 1944) and E/WaA135 (late 1944-45). In total 323.000 P.38 pistols were produced by Mauser during the Nazi regime.

byf42

 

Mauser: SVW serie

The secret Mauser code byf was replaced in 1945 by the code SVW. In april 1945 the Allied forces conquered the Mauser factory and became under control of the French. the French used the factory to produce P.38 pistols for their own use and they kept using the SVW acceptance code till mid 1946. A schematical representation of this variation is shown below.

svw45

Spreewerk:

The third manufacturer of P.38 pistols was the Spreewerk factory. Spreewerk production started in 1942 and the secret code was cyq. Spreewerk also used serial numbers with suffix letters and applied to same serial numbering system as Mauser. In february 1945 a pistol with serial number 10000z was produced and a new way of counting had to be introduced because all the letters from the alphabet were finished. Spreewerk decided to start recounting but instead of putting a suffix letter they now decided to use a prefix letter. So the first serial number after 10000z became a1. Two months later the Germans decided to abandon this form of counting and introduced a new system. A 0 was now place before the serial number and no suffix/prefix letter was added anymore. This variation was called the zero series Spreewerk variation. The Russian army conquered the factory one month later and around 100 more pistols were produced under Russian control before the factory was dismantled. Pistols produced under Russian control have a serial number that start with 00 in stead of one 0 and this variation is called the double zero series variation. In total 282.080 pistols were produced by the Spreewerk factory.

spreewerk cyq